Your cart contains 0 itemsView Cart
Dear Customers,
Please note that September 24th 2018 is a public bank holiday in Bulgaria. This means that no orders will be processed on that date and replies from the technical support team might take a little longer than usual. Thank you in advance for the understanding!
CATEGORIES
LINK TO THIS

PRODUCT DESCRIPTION

PN017 - BSI, Instrument Cluster Data Manager

PN017 - BSI, Instrument Cluster Data Manager

mpn: PN017

Not Rated

€1,380.00

Software configuration Number configuration number tip
Login for check
Qty:
bullet_arrow_up
bullet_arrow_down
Please configure the software to the hardware that I will buy right now

DESCRIPTION

PN017 is a function dedicated to the Instrument cluster and BSI odometer data calibration in Peugeot/ Citroën. With this special function you can read and calibrate the mileage stored in the BSI module and remove the synchronization with the instrument cluster (i.e. The modification is performed in the BSI exclusively and after a complete ignition cycle the mileage is not restored to the original value). In the cases where the sync removal does not apply it can calibrate the mileage in the cluster exclusively. Supported models are all CAN and UDS protocol models which includes almost all models produced after 2004.Support for Delphi UDS BSI 2016+ included.  


Supported Vehicles for Calibration: 

Peugeot

Citroën

1007
207
307 2005+
208 2012+
2008 2013+
301 2012+
Citroën Berlingo 2008+
308
3008
508
5008
407
607 2006+
807 2006+
Expert II
Partner 2008+
Citroen C3 2013
Citroen Jumpy 2016+
Toyota ProAce 2016+
Peugeot 3008 II
Peugeot 308 II2016+
Peugeot Expert2017+
Peugeot 5008 II

 

C-Elysee 2012+
C2
C3 2006+
C3 II
DS3
C4
C4 Picasso
C4 II
DS4
C5 2004+
C5 II 2007+
DS5
C6
C8 2007+
Jumpy II
Lancia Phedra 2008+
Peugeot Expert 2016
Citroen C3 Picasso 2013
Citroen C3 Aircross 2013+
Citroen C32016+
Citroen C4Picasso II2016+
Citroen Jumpy2017+
Toyota ProAce 2017+
Citroen C3 2013
Citroen Jumpy 2016+
Toyota ProAce 2016+
C3 III
C4 II Picasso 2016+
DS7

BSI Exchange - allows you to read the whole content of the
one BSI (JCI or Valeo CAN) and transfer it to another one. It is very important to use the same hardware type for the replacement BSI. The Valeo BSIs are two types – the old one is thick, while the new one is thin, so they can’t be mistaken. To use this special function you need to have PN017 + PN018 special functions. The UDS BSI modules are supported via read/write EEPROM and flash.

N.B. Please note that you will require an AVDI interface with an active AMS in order to use this special function. Absolutely no tokens required.

REVIEWS (0)

Write Review
Your Name:


Your E-Mail:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below: